- Electronic Universal Testing Machine
- Hydraulic Universal Testing Machine
- Dynamic Fatigue Testing System
-
Horizontal Tensile Testing Machine
-
Robot Automated Testing Systems
- Impact Testing Machine Series
- Compression Testing machine
- Torsion Testing Machine
- Bending Testing Machine
-
Creep and Rupture Testing Machine
-
Elastomeric Bearing Testing Machine
- Spring Testing Machine
-
Insulator Testing Machine
- Metallographic
- Hardness Tester
- Microscope
-
Plastic Pipes and Rubber Test Machine
- Melt Flow Index Tester
- HDT&VICAT Softening Point Temperature Tester
- Pendulum Impact Tester
- Hydrostatic Pressure Tester
- Plastic Pipes Ring Stiffness Tester
- Differential Scanning Calorimeter
- Moisture Meter
- Density Tester
- Ash Content Tester
- Falling Mass Impact Testing Machine
- Methylene Chloride Soak Tester
- Flame Resistance Tester
- Milling Machines
- Rubber industry testing equipment
- Environmetal Test Chamber
- Optical Spectrometer
-
Other testing equipment
- Testing equipment for masks and protective Cover
- High And Low Temperature Test Chamber
- NDT Equipment Series
- Vision Measuring Machine
- Optical Profile Projector
- Coordinate Measuring Machine
- Paper and Package Test Tester
- Textile Test tester
- Optical Test Machine
- Cupping Testing Machine
- Bolt testing equipment
- Friction and wear testing machine
- Testing machine accessories
Optical Fiber Cable Abrasion Testing Machine GMS-100 Series
1 Overview
GMS-100 Series Optical Fiber Cable Abrasion Testing Machine is intended to determine the ability of optical fiber cable withstand Abrasion
Object
The abrasion resistance of optical fiber cables has two aspects:a) The ability of the sheath to resist abrasion;
b) The ability of cable markings to resist abrasion.
The purpose of this test is to determine the ability of an optical fiber cable sheath to resist abrasion. Abrasion testing of cable markings is method E2B.
Apparatus
The abrasion test rig consists of a device designed to abrade the surface of the cable in both directions parallel to the longitudinal axis of the cable over a length of 10 mm ± 1 mm at a frequency of 55 cycles/min ± 5 cycles/min. One cycle consists of one abrading edge movement in each direction.The abrading edge shall be a steel needle with a diameter as specified in the detail specification.
2 Technical Parameters
1. Attrition stroke: 100mm;2. Setting range of testing times: 1～9999;
3. Frequency: 55±5 times/min; 4. Poise: 10~100N
5. Power supply requirement: 3-phase 4-wire, 50Hz, 0.37KW;
6. Ambient temperature: 10℃～40℃.
7. Ambient humidity: less than 80% (Non-dewfall).
